Question
a.
a straight line
b.
a circle
c.
an ellipse
d.
a rectangle
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. If two time varying signals of equal magnitudes and 90° phase displacement are applied to X and Y plates of CRO, the display will be
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. It is required to measure the true open circuit emf of a battery. The best device is
View solution
Q. Basically a potentiometer is a device for
View solution
Q. The material used in RTD is
View solution
Q. A data signal having frequency components from dc to 50 Hz is to be sent through pulse code modulation using an 8 digit code. The minimum carrier channel bandwidth is
View solution
Q. Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.
Reason (R): The time base generator develops a saw tooth voltage.
View solution
Q. Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.
Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.
View solution
Q. Consider the following galvanometers
1. D'Arsonval
2. Ballistic
3. Vibration
Which of these are permanent magnet moving coil instruments?
View solution
Q. A direct current can be measured
View solution
Q. The term 'Poisson's ratio' is connected with
View solution
Q. While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.
View solution
Q. The flow rate of electrically conducting liquid without any suspended particle can not be measured by
View solution
Q. An electrostatic voltmeter is suitable for
View solution
Q. Harmonic distortion analyser
View solution
Q. Which of the following, is not a piezoelectric material?
View solution
Q. Assertion (A): An RTD uses platinum coil.
Reason (R): Platinum is a very stable material.
View solution
Q. Assertion (A): For best results the system of a D'Arsonval galvanometer should be slightly under damped.
Reason (R): Degree of damping affects the time taken by the instrument to come to final position.
View solution
Q. Crompton potentiometer has
View solution
Q. A resistance strain gauge has a resistance of about
View solution
Q. For measuring inductance with high Q, we should use
View solution
Q. A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
