Q. Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.

Reason (R): The time base generator develops a saw tooth voltage.

View solution

Q. Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

View solution

Q. Consider the following galvanometers

1. D'Arsonval
2. Ballistic
3. Vibration

Which of these are permanent magnet moving coil instruments?

View solution

Q. A direct current can be measured

View solution

Q. The term 'Poisson's ratio' is connected with

View solution

Q. While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.

View solution

Q. The flow rate of electrically conducting liquid without any suspended particle can not be measured by

View solution

Q. An electrostatic voltmeter is suitable for

View solution

Q. Harmonic distortion analyser

View solution

Q. Which of the following, is not a piezoelectric material?

View solution

Q. Assertion (A): An RTD uses platinum coil.

Reason (R): Platinum is a very stable material.

View solution

Q. Assertion (A): For best results the system of a D'Arsonval galvanometer should be slightly under damped.

Reason (R): Degree of damping affects the time taken by the instrument to come to final position.

View solution

Q. Crompton potentiometer has

View solution

Q. A resistance strain gauge has a resistance of about

View solution

Q. For measuring inductance with high Q, we should use

View solution

Q. A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be

View solution

Q. A coil resonates at 1 MHz with a resonating capacitance of 72 pF. At 500 pF, resonance is obtained with a resonating capacitor of 360 pF. The self capacitance of coil is

View solution

Q. Two wattmeter method for 3 phase power measurement can be used only for

View solution

Q. A linear displacement digital transducer generally uses

View solution

Q. To measure an unknown ac voltage by an ac potentiometer it is desirable that supply for the potentiometer is taken

View solution