Question

Harmonic distortion analyser

a.

measures amplitude of each harmonic

b.

measures rms value of fundamental frequency component

c.

measures rms value of all harmonics except fundamental frequency

d.

displays rms value of each harmonic on screen of CRO

Answer: (c).measures rms value of all harmonics except fundamental frequency

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Harmonic distortion analyser

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. An electrostatic voltmeter is suitable for

Q. The flow rate of electrically conducting liquid without any suspended particle can not be measured by

Q. While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.

Q. The term 'Poisson's ratio' is connected with

Q. A direct current can be measured

Q. Consider the following galvanometers

1. D'Arsonval
2. Ballistic
3. Vibration

Which of these are permanent magnet moving coil instruments?

Q. Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Q. Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.

Reason (R): The time base generator develops a saw tooth voltage.

Q. A data signal having frequency components from dc to 50 Hz is to be sent through pulse code modulation using an 8 digit code. The minimum carrier channel bandwidth is

Q. The material used in RTD is

Q. Basically a potentiometer is a device for

Q. It is required to measure the true open circuit emf of a battery. The best device is

Q. If two time varying signals of equal magnitudes and 90° phase displacement are applied to X and Y plates of CRO, the display will be

Q. Measurement of non-electrical quantity involves the following subsystems

1. Amplifier block
2. Display block
3. Instrumentation block
4. Transducer block

The correct sequence of these blocks is

Q. An oscilloscope has an input impedance consisting of 1 MΩ and 20 pF is parallel. A high impedance probe connected to input of this oscilloscope has a 10 MΩ series resistance. This 10 MΩ series resistance

Q. Which of the following is used as detector in audio frequency ac bridges?

Q. Assertion (A): The gall tinsley potentiometer is a coordinate potentiometer and has two exactly similar potentiometers.

Reason (R): An ac potentiometer may measure the unknown voltage in polar form or rectangular coordinate form.

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!