Question

A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is

a.

20%

b.

50%

c.

100%

d.

200%

Answer: (d).200%

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The disadvantage of direct coupled amplifiers is

Q. A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is

Q. An ideal power supply has

Q. In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will

Q. A P-channel MOSFET operating in the enhancement mode is characterized by Vt = - 4 V and IDQ = - 10 mA, when VGSQ = - 5.5 V, what will be VGSQ if IDQ = -15 mA and ID, on = - 16 mA

Q. In a transistor E mode the collector current with the transistor in cut off region is

Q. Two CE stages, 1 and 2 are coupled through a capacitor. VCC is the same for both. Base resistances RB1 and RB2 are such that RB1 > RB2. Then

Q. In a two stage CE amplifier circuit, the ac collector resistance of the first stage depends on

Q. In a CE amplifier the ac cut off voltage is 9 V and slope of ac load line is - 0.5 mA/V. The ac saturation current is

Q. A differential amplifier consists of two CB amplifiers.

Q. A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is

Q. An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be

Q. A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are

Q. When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is

Q. When load is coupled to class A amplifier through transformer, efficiency decreases.

Q. The gain of an FET amplifier can be changed by changing

Q. The open loop gain of an actual op-amp is about 100.

Q. The units of transistor h parameters h11 and h22 are the same.

Q. Positive feedback is mainly used in

Q. For a BJT if β = 50, ICEO = 3 μA and IC = 1.2 mA then IB

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!