Question
a.
True
b.
False
c.
May be True or False
d.
can't say
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The units of transistor h parameters h11 and h22 are the same.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Positive feedback is mainly used in
View solution
Q. For a BJT if β = 50, ICEO = 3 μA and IC = 1.2 mA then IB
View solution
Q. The main application of enhancement mode MOSFET is in
View solution
Q. In a commercially available good power supply the voltage regulation is about
View solution
Q. The most commonly used bias in BJT amplifier circuits is
View solution
Q. For dc the current through coupling capacitor in CE amplifier circuit is
View solution
Q. In a CE amplifier the collector resistance is short circuited. The ac output voltage will
View solution
Q. In a transistor CE mode, VCC = +30 V. If the transistor is in cut off region, VCE =
View solution
Q. The dc load current in a bridge rectifier circuit is 10 mA. The dc load current through each diode is
View solution
Q. An integrating amplifier has resistance in feedback path.
View solution
Q. Values of VT at 20°C for an ideal P-N diode
View solution
Q. Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement
Reason (R): Large value capacitor can also be fabricated on a chip
View solution
Q. A negative feedback can be of
View solution
Q. In a class C power amplifier the input frequency of ac signal is 1 MHz. If tank circuit has C = 1000 pF, the value of L =
View solution
Q. In calculating output impedance of an amplifier the source is replaced by an open circuit.
View solution
Q. For transistor 2 N 338 the manufacturer specifies Pmax = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
View solution
Q. A 120 V, 30 Hz source feeds a half wave rectifier circuit through a 4 : 1 step down transformer, the average output voltage is
View solution
Q. The slew rate of an ideal op-amp is
View solution
Q. Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
View solution
Q. Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance
Reason (R): Negative feedback increases output impedance
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
