Question
a.
Circuit using BJT
b.
Circuit using JFET
c.
Circuit using MOSFET
d.
Either (a) or (b)
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following amplifier circuits has highest input impedance?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
View solution
Q. A differentiating amplifier has capacitor in the input path.
View solution
Q. Which of the following statement about TRIAC is incorrect?
View solution
Q. A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are
View solution
Q. Overall efficiency of class B amplifier is
View solution
Q. For a transistor to have-a larger β it must have and a
View solution
Q. JFET is also known as
View solution
Q. Drain feedback bias is often used with
View solution
Q. CMRR of a difference amplifier is equal to
View solution
Q. The ac collector current is nearly equal to
View solution
Q. From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
View solution
Q. In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be
View solution
Q. Assertion (A): If we overdrive an amplifier the output signal may get clipped
Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor
View solution
Q. Which op-amp circuit uses a diode as one of the circuit components?
View solution
Q. Tuned amplifiers are used at radio frequencies.
View solution
Q. The knee voltages in silicon and germanium diodes respectively are
View solution
Q. In calculating input impedance, the load impedance is considered to be connected at the output.
View solution
Q. In a transistor βdc is likely to vary between 100 and 400. The proper value of βdc to be used to located Q point is
View solution
Q. Which of the following noise becomes of great importance at high frequencies?
View solution
Q. High cut off frequency can be expected in case of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!