Question

For a transistor to have-a larger β it must have and a

a.

close to zero

b.

close to 0.5

c.

close to unity

d.

nearly infinite

Answer: (c).close to unity

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. For a transistor to have-a larger β it must have and a

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. JFET is also known as

Q. Drain feedback bias is often used with

Q. CMRR of a difference amplifier is equal to

Q. The ac collector current is nearly equal to

Q. From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier

Q. In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be

Q. Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

Q. Which op-amp circuit uses a diode as one of the circuit components?

Q. Tuned amplifiers are used at radio frequencies.

Q. The knee voltages in silicon and germanium diodes respectively are

Q. In calculating input impedance, the load impedance is considered to be connected at the output.

Q. In a transistor βdc is likely to vary between 100 and 400. The proper value of βdc to be used to located Q point is

Q. Which of the following noise becomes of great importance at high frequencies?

Q. High cut off frequency can be expected in case of

Q. Which coupling produces the minimum interference with frequency response?

Q. Assertion (A): A sine wave with slew rate distortion looks rectangular

Reason (R): The maximum rate of output voltage change is called slew rate

Q. In a P-N-P transistor, electrons flow

Q. A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is

Q. In a class C amplifier, full cycle conductor of the current is achieved by employing

Q. Higher order active filters are used for variable

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!