Q. Which of the following combinations has no phase inversion of the signal?

View solution

Q. Which of the following h parameters is an admittance?

View solution

Q. Assertion (A): Manufacturer's quote h parameters of transistor

Reason (R): h parameters of a transistor are easiest to measure

View solution

Q. The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to

View solution

Q. Wien bridge uses

View solution

Q. Which of the following is not necessarily the advantages of a push pull amplifier?

View solution

Q. Which of the following best represents the output impedance of an actual op-amp?

View solution

Q. The phase angle of lead circuit is

View solution

Q. A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is

View solution

Q. The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.

View solution

Q. In CE amplifier

View solution

Q. The phase angle of a lag circuit is

View solution

Q. CMOS is widely used in

View solution

Q. A JFET can operate on

View solution

Q. Which of the following is the point of reference JFET?

View solution

Q. A Darlington pair consist of

View solution

Q. The ripple factor of a full wave rectifier is about 0.5

View solution

Q. Which of the following statement is false?

View solution

Q. The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback would be.

View solution

Q. In a CE amplifier circuit, the output voltage

View solution