Q. In amplifiers, the parasitic oscillation result due to

View solution

Q. A ripple in collector supply voltage of the output stage of amplifier causes noise.

View solution

Q. In a transistor IE = 10 mA, ICO = 0.5 μA and α = 0.995. Then ICEO =

View solution

Q. As a compared to a CB amplifier, a CE amplifier has

View solution

Q. The stray capacitance between the last stage and the first stage of an oscillator may cause

View solution

Q. In a voltage regulator circuit using zener diode the load voltage is nearly constant only if

View solution

Q. Negative feedback in amplifier

View solution

Q. Which of the following is the fastest switching device?

View solution

Q. Which of the following is not valid in case of bipolars?

View solution

Q. The input resistance of JFET ideally approaches

View solution

Q. In the analysis of common emitter amplifier we may neglect

View solution

Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is

View solution

Q. Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

View solution

Q. In CB amplifier the distortion of the input voltage waveform may occur due to

View solution

Q. As compared to full wave rectifier, a half wave rectifier

View solution

Q. Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors

Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

View solution

Q. In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as

View solution

Q. A sine wave with slew rate distortion looks like

View solution

Q. If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will

View solution

Q. A boot strap generally incorporates

View solution