Question
a.
unwanted low frequency oscillations
b.
unwanted high frequency oscillations
c.
unwanted oscillations at low and high frequencies
d.
large feedback
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The stray capacitance between the last stage and the first stage of an oscillator may cause
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a voltage regulator circuit using zener diode the load voltage is nearly constant only if
View solution
Q. Negative feedback in amplifier
View solution
Q. Which of the following is the fastest switching device?
View solution
Q. Which of the following is not valid in case of bipolars?
View solution
Q. The input resistance of JFET ideally approaches
View solution
Q. In the analysis of common emitter amplifier we may neglect
View solution
Q. A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is
View solution
Q. Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.
Reason (R): Hartley oscillator uses a tapped inductor
View solution
Q. In CB amplifier the distortion of the input voltage waveform may occur due to
View solution
Q. As compared to full wave rectifier, a half wave rectifier
View solution
Q. Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors
Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.
View solution
Q. In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
View solution
Q. A sine wave with slew rate distortion looks like
View solution
Q. If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
View solution
Q. A boot strap generally incorporates
View solution
Q. The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
View solution
Q. Power transistors are invariably provided with
View solution
Q. Assertion (A): The ac load line is different from dc load line
Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance
View solution
Q. In a class C operation VCC = 40 V and VCE(sat) = 0.4 V. The efficiency is
View solution
Q. The absolute values of pinch-off voltage and gate-source cut-off voltage are
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
