Q. In order to rectify sinusoidal signals of millivolt range (< 0.6 V)

View solution

Q. The common gate amplifier has a characteristically __________ input resistance and a __________ output resistance.

View solution

Q. For input and later stages, BI-FET op-amp use

View solution

Q. The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage Vid only when the magnitude of Vid is less a times the thermal voltage, where α is

View solution

Q. In most transistor the collector region is made physically larger than the emitter region

View solution

Q. The leakage current in CB configuration may be around

View solution

Q. In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in

View solution

Q. Class-B amplifier has less efficiency compared to

View solution

Q. Calculate the O/P voltage of a non-inverting constant gain multiplier with R1 = 100 kΩ, Rf= 600 kΩ, V1 = 2 volt, then O/P voltage Vo of non inverting op-amp is given by

View solution

Q. Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?

View solution

Q. Saturation of iron core causes distortion.

View solution

Q. Which of the following is non-sinusoidal oscillator?

View solution

Q. Low gain-bandwidth product of a JFET is due to

View solution

Q. In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be

View solution

Q. In a base driver amplifier the voltage gain is the ratio of

View solution

Q. Assertion (A): A class C amplifier is a timed amplifier which needs a tank circuit as the load in the collector circuit of the transistor for its proper operation

Reason (R): In class C operation collector current flows for less than 180° of the ac cycle and thus flows in pulses

View solution

Q. A junction Field Effect Transistor can operate in

View solution

Q. In the case of an amplifier, the normalised voltage gain is given by.where f0 is zero frequency, fP is pole frequency. For a standard frequency response of the amplifier,

View solution

Q. In a rectifier only a portion of input power is converted into DC power. The rest is AC power.

View solution

Q. The slope of the transfer characteristics of an N-channel JFET is

View solution