Q. An electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis is

View solution

Q. Assertion (A): If the Laplace transform is G(s) = 4/(s²+2s+4), the Laplaces transform of impulse response is given by C(s) = 4/(s²+2s+4)

Reason (R): The Laplace transform for an impulse function is 1.

View solution

Q. The polar plot of G(jω) = 1/jω is the negative imaginary axis.

View solution

Q. The number of branches of root locus plot is equal to

View solution

Q. The action of bellows is similar to that of

View solution

Q. For a second order system ωn is natural frequency, ωd is frequency of damped oscillations and ζ is damping factor. Then

View solution

Q. In force voltage analogy the quantity analogous to spring constant K is

View solution

Q. The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.

View solution

Q. Time rate of change in heat energy is analogous to

View solution

Q. Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input.

Reason (R): For a type of system velocity error is zero.

View solution

Q. The shape of torque-speed curve of a two phase servo- motor mostly depends on

View solution

Q. In a lag network the input frequency is 100 fc where fc is critical frequency. The voltage gain is

View solution

Q. Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

View solution

Q. Assertion (A): Most of actual systems are non-linear.

Reason (R): Non linearity may be due to saturation, dead zone, square law etc.

View solution

Q. The correct sequence of events to improve system stability is

View solution

Q. Assertion (A): For an underdamped system with damping ratio ξ, the maximum overshoot is e-ξπ/(1-ξ²)^0.5

Reason (R): Peak time of a second order under damped system = π/ωd where ωd is frequency of damped oscillations.

View solution

Q. I-PD controlled system has

View solution

Q. Assertion (A): Laplace transform of impulse function is equal to area under the impulse.

Reason (R): An impulse function whose area is unity is called unit impulse function.

View solution

Q. Optical encoders most commonly used in control systems are

View solution

Q. A second order system exhibits 100% overshoot. The damping ratio is

View solution