Q. A first-order system has a time constant t. For unit ramp input, the steady state error is

View solution

Q. Consider the following statements relating to synchros

1. Rotor of control transformer is either disc shaped or umbrella shaped
2. Rotor of transmitter has low magnetic reluctance
3. Transmitter and control transformer pair act as error detector

Out of above the correct statements are

View solution

Q. For a second order system the damping factor is varied from 0 to 1. The locus of poles is

View solution

Q. In a synchro transmitter, which coil acts as primary?

View solution

Q. Assertion (A): The transient performance of a control system is generally analysed by using unit step function as reference input.

Reason (R): Impulse is the most common input found in practice.

View solution

Q. If a zero is added to a second order underdamped system

View solution

Q. PID controlled system has

View solution

Q. In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is

View solution

Q. For Bode plot of (1 + jωT) has

View solution

Q. The purpose of series quadrature windings in amplidyne is to

View solution

Q. For the transport lag G(jω) = e^(-jωT), the phase angle

View solution

Q. In classical analogue, torque is analogous to

View solution

Q. The open loop transfer function of a system is K/s(Js+F). If the frequency at the intersection of - 40 dB/decade line and 0 dB line is ω, then

View solution

Q. For low frequencies such that ω << 1/T , the log magnitude of factor 1/(1+jωT) is 0 dB.

View solution

Q. Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

View solution

Q. The capacitance of a gas pressure vessel is defined as

View solution

Q. Assertion (A): Integral control action is sometimes called reset control.

Reason (R): Reset rate is expressed as number of repeats per unit time.

View solution

Q. In some on-off controllers a differential gap is provided

View solution

Q. If G(s) = 1/(s³+s²+1), there are

View solution

Q. In Bode analysis the correction at corner frequency is 3 dB.

View solution