Q. Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz

View solution

Q. In a ratio detector

View solution

Q. Neutralization is used in RF amplifiers to

View solution

Q. It is known that noise phase modulates the FM wave. As the noise side band frequency approaches the carrier frequency, the noise amplitude

View solution

Q. A transmitter serial current contains

View solution

Q. In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 25 MHz will be

View solution

Q. In a communication system, noise is most likely to affect the signal

View solution

Q. The noise produced by a resistor is proportional to

View solution

Q. In a radio receiver, if the intermediate frequency is too high

View solution

Q. In a receiver, which of the following device has IF input but RF output?

View solution

Q. Transistor are free from which type of noise?

View solution

Q. Standard AM radio broadcasts are confined to

View solution

Q. In a radio receiver with simple AGC

View solution

Q. Which of the following cannot be used to demodulate SSB?

View solution

Q. In a broadcast superheterodyne receiver

View solution

Q. A duplexer is a device used to

View solution

Q. A heterodyne frequency changer is called a

View solution

Q. RF amplifiers are used in radio receivers for

View solution

Q. An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10¯⁵ ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is

View solution

Q. The output of a diode detector contains

View solution