Question
a.
the highest AGC voltage is produced between stations
b.
the faster the AGC time constant, the more accurate the output
c.
an increase in signal strength produces more AGC
d.
the audio stage gain is normally controlled by AGC
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a radio receiver with simple AGC
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which of the following cannot be used to demodulate SSB?
View solution
Q. In a broadcast superheterodyne receiver
View solution
Q. A duplexer is a device used to
View solution
Q. A heterodyne frequency changer is called a
View solution
Q. RF amplifiers are used in radio receivers for
View solution
Q. An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10¯⁵ ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
View solution
Q. The output of a diode detector contains
View solution
Q. Which of the following noise does not occur in transistors?
View solution
Q. Noise generated in a resistor is also known as
View solution
Q. Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
View solution
Q. The noise generated by a resistor depends upon
View solution
Q. In a superheterodyne receiver
View solution
Q. The function of an AM detector circuit is to
View solution
Q. Which of the following should be used in order to prevent overloading or the last IF amplifier in a receiver?
View solution
Q. Most popular IF for receivers tuning to 540 to 1650 kHz is
View solution
Q. In superheterodyne receivers, the local oscillator is used to
View solution
Q. Which of the following is same in AM and FM receivers?
View solution
Q. A notch filter is sometimes used in communication receivers to
View solution
Q. Which one of the following is not a useful quantity for comparing the noise performance of receivers?
View solution
Q. Which of the following statement about the amplitude limiter is not valid?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
