Question

A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) where g(t) is given by below equation. The resulting signal is then passes through an ideal low pass filter with bandwidth 1 kHz the output of the low pass filter would be

a.

δ(t)

b.

m(t)

c.

0

d.

m(t) δ(t)

Answer: (b).m(t)

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) where g(t) is given by below equation. The resulting signal is then passes through an ideal low pass filter...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. If a signal voltage Vs is accompanied by a noise voltage Vn the signal to noise ratio is

Q. A sequence x(n) with the z transform X(z) = z⁴ + z² - 2z + 2 - 3z - 4 is applied as an input to a linear, time invariant system with the impulse response h(n) = 2δ(n - 3) where δ(n) is given below. The output at n = 4 is

Q. In a satellite transponder the power amplifier feeds power P to the transmitting antenna of gain G. If distance of earth is d, the power flux density is

Q. In a two stage cascade amplifier the equivalent noise temperatures are Te1 and Te2. If the gains of the two stages are G1 and G2, the overall noise temperature Te is

Q. A π matching network for coupling the transmitter output of the antenna is shown in figure.
In this C₂ should be tuned for

Q. In figure (A) and (B)

Q. For a three stage cascaded amplifier, having gains of G₁, G₂ and G₃ and noise figures of F₁, F₂, F₃ the overall noise figure

Q. Which of the following could be the equation for non-linear resistor shown in figure?

Q. Figure shows the arrangement of

Q. Noise figure is defined as

Q. If N is the number of binary digits needed to assign individual binary code designations to the M quantization levels, the signal to quantization noise ratio S0/Nq in PCM is

Q. If Vs is signal voltage, Vn is noise voltage, signal to noise ratio S/N is defined as

Q. The PDF of a Gaussian random variable X is given by following equation. The probability of the event {X = 4} is

Q. A single tone modulating signal Vm cos ωt modulates a carrier A cos ωct. The carrier power (modulated) and side band powers are respectively

Q. Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded that

Q. If f is frequency and d is distance, path attenuation a between isotropic antennas is given by

Q. If the transmitted pulse power of a radar is Pt (peak value) and the antenna is isotropic, the power density at a distance r is

Q. In delta modulation, the output signal to quantization noise ratio S0/Nq is (N is the number of bits)

Q. If B is channel bandwidth, S is signal power and N is the total noise within the channel bandwidth, the channel capacity C of a white band limited gaussian channel is

Q. For an RC low pass filter, the relation between noise bandwidth BN and 3-dB bandwidth B3dB is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!