Q. In a two stage cascade amplifier the equivalent noise temperatures are Te1 and Te2. If the gains of the two stages are G1 and G2, the overall noise temperature Te is

View solution

Q. A π matching network for coupling the transmitter output of the antenna is shown in figure.
In this C₂ should be tuned for

View solution

Q. In figure (A) and (B)

View solution

Q. For a three stage cascaded amplifier, having gains of G₁, G₂ and G₃ and noise figures of F₁, F₂, F₃ the overall noise figure

View solution

Q. Which of the following could be the equation for non-linear resistor shown in figure?

View solution

Q. Figure shows the arrangement of

View solution

Q. Noise figure is defined as

View solution

Q. If N is the number of binary digits needed to assign individual binary code designations to the M quantization levels, the signal to quantization noise ratio S0/Nq in PCM is

View solution

Q. If Vs is signal voltage, Vn is noise voltage, signal to noise ratio S/N is defined as

View solution

Q. The PDF of a Gaussian random variable X is given by following equation. The probability of the event {X = 4} is

View solution

Q. A single tone modulating signal Vm cos ωt modulates a carrier A cos ωct. The carrier power (modulated) and side band powers are respectively

View solution

Q. Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded that

View solution

Q. If f is frequency and d is distance, path attenuation a between isotropic antennas is given by

View solution

Q. If the transmitted pulse power of a radar is Pt (peak value) and the antenna is isotropic, the power density at a distance r is

View solution

Q. In delta modulation, the output signal to quantization noise ratio S0/Nq is (N is the number of bits)

View solution

Q. If B is channel bandwidth, S is signal power and N is the total noise within the channel bandwidth, the channel capacity C of a white band limited gaussian channel is

View solution

Q. For an RC low pass filter, the relation between noise bandwidth BN and 3-dB bandwidth B3dB is

View solution

Q. The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could be

View solution

Q. When E1, E2, E3 etc. are the simultaneous modulating voltages, then the total modulating voltage Et will be

View solution

Q. The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this modem?

View solution