Question

A π matching network for coupling the transmitter output of the antenna is shown in figure.
In this C₂ should be tuned for

a.

minimum D.C. plate current

b.

maximum D.C. plate current

c.

maximum RF antenna current

d.

specified value of the D.C. plate current

Answer: (b).maximum D.C. plate current

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A π matching network for coupling the transmitter output of the antenna is shown in figure. In this C₂ should be tuned for

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In figure (A) and (B)

Q. For a three stage cascaded amplifier, having gains of G₁, G₂ and G₃ and noise figures of F₁, F₂, F₃ the overall noise figure

Q. Which of the following could be the equation for non-linear resistor shown in figure?

Q. Figure shows the arrangement of

Q. Noise figure is defined as

Q. If N is the number of binary digits needed to assign individual binary code designations to the M quantization levels, the signal to quantization noise ratio S0/Nq in PCM is

Q. If Vs is signal voltage, Vn is noise voltage, signal to noise ratio S/N is defined as

Q. The PDF of a Gaussian random variable X is given by following equation. The probability of the event {X = 4} is

Q. A single tone modulating signal Vm cos ωt modulates a carrier A cos ωct. The carrier power (modulated) and side band powers are respectively

Q. Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded that

Q. If f is frequency and d is distance, path attenuation a between isotropic antennas is given by

Q. If the transmitted pulse power of a radar is Pt (peak value) and the antenna is isotropic, the power density at a distance r is

Q. In delta modulation, the output signal to quantization noise ratio S0/Nq is (N is the number of bits)

Q. If B is channel bandwidth, S is signal power and N is the total noise within the channel bandwidth, the channel capacity C of a white band limited gaussian channel is

Q. For an RC low pass filter, the relation between noise bandwidth BN and 3-dB bandwidth B3dB is

Q. The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could be

Q. When E1, E2, E3 etc. are the simultaneous modulating voltages, then the total modulating voltage Et will be

Q. The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this modem?

Q. What is the RF amplifier plate voltage when the audio-modulating voltage is +600 V?

Q. If carrier power is P and amplitude modulation index is m, the total power after modulation is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!