Q. In the given figure the reflected voltage wave after first reflection is

View solution

Q. For the strip line in the given figure the capacitance per unit length =

View solution

Q. In mode filter of the given figure which of the following modes is unaffected

View solution

Q. The component in the given figure is

View solution

Q. In the given figure the reflected current wave after first reflection is

View solution

Q. In a microwave coaxial line, the maximum operating frequency is f max and breakdown strength of dielectric is Ed' Then maximum power handling capacity is proportional to

View solution

Q. In the given figure the E and H lines in a coaxial cable

View solution

Q. When a line is loaded the characteristic impedance is equal to

View solution

Q. In the given figure forward current wave has a magnitude of

View solution

Q. In the given figure shows the equivalent circuit of a magic tee. If all ports are matched

View solution

Q. In the given figure forward voltage wave has a magnitude

View solution

Q. For a rectangular waveguide having width a and height b, the cutoff wavelength for TM₁₁ mode is equal to

View solution

Q. If ZTE is wave impedance for TE waves, Ed is maximum dielectric strength of insulating material, a and b are the width and height of a rectangular wave guide, the maximum power handling capability Pmax for TE₁₀ mode is

View solution

Q. In the given figure a short circuited transmission line resonator If n = 1, 2, 3...

View solution

Q. The Q factor of a waveguide resonator is given by (ω0 is resonant frequency, U is energy storage and WL is the power loss)

View solution

Q. For l << λ, the equivalent circuit of a microwave resistor is

View solution

Q. If μr is relative permeability, ∈r is relative permittivity, c is velocity of light fc is cutoff frequency, phase velocity vp (i.e., speed with which a particular phase of the wave travels down a rectangular waveguide at frequency f) is given by

View solution

Q. A square waveguide carries TE₁₁ mode whose axial magnetic field is given by following equation, where the guide dimensions are in cms. The cut off frequency of the mode is

View solution

Q. In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port 3 is

View solution

Q. In the given figure the line voltage after a number of reflections will be

View solution