Q. What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

1. Emitter diffusion
2. Base diffusion
3. Buried layer formation
4. E pi-layer formation

Select the correct answer using the codes given below:

View solution

Q. For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (VSB > 0), the threshold voltage VT of the MOSFET will

View solution

Q. Which of the following is used for generating time varying wave forms?

View solution

Q. Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm¯³. Density of electrons = 8 x 10¹³ cm¯³, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.

View solution

Q. The static characteristic of an adequately forward biased P-n junction is a straight line, if the plot is of __________ Vs → versus

View solution

Q. In an n channel JFET

View solution

Q. The intrinsic carrier concentration of silicon sample at 300 K is 1.5 x 10¹⁶/m³. If after doping, the number of majority carriers is 5 x 10²ᴼ/m³. The minority carrier density is

View solution

Q. A diode is operating in forward region and the forward voltage and current are v = 3 + 0.3 sin ωt (volts) and i = 5 + 0.2 sin ωt (mA). The average power dissipated is

View solution

Q. Which statement is false as regards holes

View solution

Q. Photo electric emission can occur only if

View solution

Q. The reverse saturation current of a diode does not depend on temperature.

View solution

Q. In a piezoelectric crystal, application of a mechanical stress would produce

View solution

Q. The value of α in a transistor

View solution

Q. The amount of photoelectric emission current depends on the frequency of incident light.

View solution

Q. When a p-n junction is forward biased

View solution

Q. The carriers of n channel JFET are

View solution

Q. The depletion layer around p-n junction in JFET consists of

View solution

Q. Junction temperature is always the same as room temperature.

View solution

Q. Assertion (A): A p-n junction has high resistance in reverse direction.
Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

View solution

Q. Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.

Reason (R): High reverse voltage causes Avalanche effect.

View solution