Q. Measurement of Hall coefficient enables the determination of

View solution

Q. The units for transconductance are

View solution

Q. The mean free path of conduction electrons in copper is about 4 x 10¯⁸ m. For a copper block, find the electric field which can give, on an average, 1 eV energy to a conduction electron

View solution

Q. When a p-n-p transistor is properly biased to operate in active region the holes from emitter.

View solution

Q. Assertion (A): Silicon is preferred over germanium in manufacture of semiconductor devices.

Reason (R): Forbidden gap in silicon is more than that in germanium.

View solution

Q. Assertion (A): A decrease in temperature increases the reverse saturation current in a p-n diode.

Reason (R): When a diode is reverse biased surface leakage current flows.

View solution

Q. At room temperature a semiconductor material is

View solution

Q. The threshold voltage of an n-channel enhancement mode MOSFET is 0.5 when the device is biased at a gate voltage of 3V. Pinch off would occur at a drain voltage of

View solution

Q. Which of these has degenerate p and n materials?

View solution

Q. A Schottky diode clamp is used along with switching BJT for

View solution

Q. In a piezoelectric crystal, applications of a mechanical stress would produce

View solution

Q. What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor? Emitter diffusionBase diffusionBuried layer formationE pi-layer formation Select the correct answer using the codes given below:

View solution

Q. Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 1012 cm-3. Density of electrons = 8 x 1013 cm-3, mobility of conduction electron = 2.3 x 104 cm²/ V-sec and mobility of holes = 100 cm²/V-sec.

View solution

Q. A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is

View solution

Q. Between which regions does BJT act like switch?

View solution

Q. Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

View solution

Q. Which of the following elements act as donor impurities?

1. Gold
2. Phosphorus
3. Boron
4. Antimony
5. Arsenic
6. Indium

Select the answer using the following codes :

View solution

Q. Light dependent resistor is

View solution

Q. The derating factor for a BJT transistor is about

View solution

Q. An intrinsic silicon sample has 2 million free electrons. The number of holes in the sample is

View solution