Question

Measurement of hall coefficient enables the determination of

a.

mobility of charge carriers

b.

type of conductivity and concentration of charge carriers

c.

temperature coefficient and concentration of charge carriers

d.

fermi level and forbidden energy gap

Answer: (b).type of conductivity and concentration of charge carriers

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Measurement of hall coefficient enables the determination of

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which of these has 3 layers?

Q. For an P-channel enhancement type MOSFET determine the drain current if K = 0.278 x 10¯³A/V², VGS = -4V, VT = -2V, Voltage equivalent at 27°C = 26 mV.

Q. The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately

Q. When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.

Q. In which material do conduction and valence bands overlap

Q. For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in illumination results in

Q. The number of p-n junctions in a semiconductor diode are

Q. Assertion (A): A high junction temperature may destroy a diode.

Reason (R): As temperature increases the reverse saturation current increases.

Q. A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?

Q. Assertion (A): In design of circuit using BJT, a derating factor is used.

Reason (R): As the ambient temperature increases, heat dissipation becomes slower.

Q. If the drift velocity of holes under a field gradient of 100 V/m is 5m/sec. Their mobility is

Q. In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹ᴼ/ cm³ the electron concentration is

Q. The behaviour of a JFET is similar to that of

Q. Dielectric strength of polythene is around

Q. Resistivity of hard drawn copper is

Q. The channel of JFET consists of

Q. In a bipolar junction transistor αdc = 0.98, ICO= 2 μA and 1B = 15 μA. The collector current IC is

Q. The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be

Q. As temperature increases the forbidden gap in silicon increases.

Q. Assertion (A): Germanium is more commonly used than silicon.

Reason (R): Forbidden gap in germanium is less than that in silicon.

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!