Q. For BJT, under saturation condition

View solution

Q. An inductor filter has a ripple that __________ with load resistance and consequently is used only with relatively __________ load currents.

View solution

Q. In a JFET

View solution

Q. Introducing a resistor in the emitter of a common amplifier stabilizes the d.c. operating point against variations in

View solution

Q. If the atomic number of germanium is 32, the number of electrons in the outer most shell will be

View solution

Q. Dielectric loss due to polarisation occurs in

View solution

Q. A metal loses electrons at room temperature.

View solution

Q. Consider the following statement associated with bipolar junction transistor and JFET

1. The former has higher input impedance than the later
2. The former has higher frequency stability than the later
3. The later has lower noise figure than the former
4. The later has higher power rating than the former

Of these statements

View solution

Q. The turn off time of a bipolar transistor is about

View solution

Q. Hystresis loss least depends on

View solution

Q. In a bipolar transistor, emitter efficiency is about

View solution

Q. For signal diodes the PIV rating is usually in the range

View solution

Q. The potential of suppressor grid (with respect to cathode) is usually

View solution

Q. Photoelectric effect occurs only in semiconductors and not in metals.

View solution

Q. Which of these has peak and valley points in v-i curve?

View solution

Q. The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as

View solution

Q. A full wave bridge rectifier is supplied voltage at 50 Hz. The lowest ripple frequency will be

View solution

Q. The output characteristics of a bipolar transistor has three distinct regions. They are known as

View solution

Q. Assertion (A): In a BJT, αdc is about 0.98.

Reason (R): In a BJT, recombination in base region is high.

View solution

Q. Wienbridge oscillator uses

View solution