Q. A DIAC has two terminals, anode and cathode.

View solution

Q. A single phase semiconverter has a freewheeling diode. If the firing angle is α and the load is purely resistive, the periods of conduction and freewheeling respectively are

View solution

Q. HVDC transmission systems generally use

View solution

Q. A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is α. During one cycle of input voltage, the total duration of conduction of freewheeling diode is

View solution

Q. During forward blocking state of SCR, the voltage and current respectively are

View solution

Q. In a 3 phase full converter the average load current is 150 A. The average thyristor current is

View solution

Q. The two modes of operation of three phase bridge inverters are known as

View solution

Q. To protect an SCR against high di/dt we connect

View solution

Q. In a parallel inverter

View solution

Q. A silicon controlled switch has :

View solution

Q. A dc chopper V = 500 V feeds an electric fraction dc series motor. The chopping frequency is 400 Hz. The series inductance required to limit the maximum current swing to 10 A is

View solution

Q. A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is

View solution

Q. A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct

View solution

Q. In a 3 phase semiconverter, the firing frequency is

View solution

Q. Present day HVDC converters are all

View solution

Q. A single phase full converter gives maximum and minimum output voltage at firing angles of

View solution

Q. A thyristor has its gate current zero. To start conduction the forward voltage must exceed

View solution

Q. Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR

Reason (R): Voltage across a capacitor can not change instantaneously.

View solution

Q. In dielectric heating, the thyristor circuits consist of

View solution

Q. On load tap changer using thyristors can have a maximum of two taps.

View solution