Question

Which of the following devices exhibit negative resistance characteristics?

a.

UJT

b.

PUT

c.

Both UJT and PUT

d.

UJT, PUT and SBS

Answer: (c).Both UJT and PUT

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Which of the following devices exhibit negative resistance characteristics?

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In integral cycle control of ac regulators, the period of integral cycle control, i.e., (m + n) T should be

Q. All other parameters remaining the same, a 3 phase bridge inverter with 180° mode of operation

Q. As compared to BJT, MOSFET has

Q. A current source inverter has simple commutation circuit.

Q. In load commutated chopper, the commutating element

Q. In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is

Q. Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Q. Assertion (A): Typical value of thermal resistance from source to sink of an SCR is about 0.3° C/W

Reason (R): Heat sinks of thyristors are generally made of aluminium.

Q. In a thyristors are i = kvᵃ. The value of a is

Q. In an ordinary thyristor

Q. Thyristors connected in series need :

Q. If 4 quadrant operation is required we need

Q. Which of these commutation methods uses an external pulse for commutation?

Q. In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle α is

Q. A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be

Q. A relaxation oscillator uses

Q. In a stud mounted SCR, the stud is

Q. In pulse width modulation of chopper

Q. In a full bridge inverter, the waveshape of load current depends on

Q. The characteristics of which device has peak point and valley point

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!