Question
a.
switching between cutoff and saturation regions
b.
switching between cutoff and active regions
c.
switching between active and saturation regions
d.
none of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. ECL has high switching speed because the transistors are
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Karnaugh map can not be drawn when the number of variables is more than 4
View solution
Q. A dynamic RAM cell which holds 5 V has to be refreshed every 20 ms so that the stored voltage does not fall by more than 0.5 V. If the cell has a constant discharge current of 0.1 pA, the storage capacitance of cell is
View solution
Q. If memory chip size is 256 x 1 bits, the number of chips required to make 1 k byte memory is
View solution
Q. Computers use RC circuit for edge triggering.
View solution
Q. The function Y = AC + BD + EF is
View solution
Q. Assertion (A): A multiplexer can be used for data routing.
Reason (R): A multiplexer has one input and many outputs.
View solution
Q. TTL is used in electronic calculators.
View solution
Q. Inverter 74 LS04 has following specifications I0H max = - 0.4 mA, I0L max = 8 mA, IIH max = 20 μA, IIL max = 0.1 mAThe fan out of this inverter is
View solution
Q. A 4 bit ripple counter starts in 0000 state. When the counter reads 0010 the number of clock pulses which have occurred is
View solution
Q. The number FF in hexadecimal system is equivalent to number __________ in decimal system.
View solution
Q. The number of switching functions of 3 variables are
View solution
Q. The applications of shift registers are
1. Time delay
2. Ring counter
3. Serial to parallel data conversion
4. Serial to serial data conversion
Which of the above are correct?
View solution
Q. Assertion (A): ECL is fast as compared to TTL.
Reason (R): ECL dissipates less power than TTL.
View solution
Q. Assertion (A): Synchronous counter has higher speed of operation than ripple counter
Reason (R): Synchronous counter uses high speed flip flops.
View solution
Q. What will be the maximum conversion time in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
View solution
Q. A multilevel decoder is more costly as compared to single level decoder.
View solution
Q. EPROM can be
View solution
Q. A full subtractor has a total of
View solution
Q. The function of interface circuit is
View solution
Q. 1274₁₆ - 3A7₁₆ = __________ .
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
