Question
Reason (R): IEEE symbols are the same as traditional symbols for gates.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R are correct but R is not correct explanation of A
c.
A is true, R is false
d.
A is false, R is true
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): Different symbols are used for different gates Reason (R): IEEE symbols are the same as traditional symbols for gates.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. If an analog voltage is expressed in binary using 4 bits, each successive binary count would represent
View solution
Q. In a 4 input AND gate, the total number of High outputs for 16 input states are
View solution
Q. Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
View solution
Q. The initial state of a Mod-16 counter is 0110. After 37 clock pulses the state of counter will be
View solution
Q. In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require
View solution
Q. A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
View solution
Q. A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
View solution
Q. Assertion (A): A demultiplexer cannot be used as a decoder
Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.
View solution
Q. Hexadecimal number F is called to octal number
View solution
Q. A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are
View solution
Q. TTL logic is preferred to DRL logic because
View solution
Q. Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits
Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.
View solution
Q. A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is
View solution
Q. What do the contents of instruction register specify?
View solution
Q. In the decimal number 27, the digital 2 represents
View solution
Q. Which of the following is true?
View solution
Q. E7F6₁₆ = __________ .
View solution
Q. What is the normal range of analog input voltage?
View solution
Q. Assertion (A): The propagation delay in ECL is minimum
Reason (R): Transistors used in ECL switch between active and cutoff regions.
View solution
Q. For the design of a sequential circuit having 9 states, minimum number of memory elements required is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
