Q. In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require

View solution

Q. A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,

View solution

Q. A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are

View solution

Q. Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

View solution

Q. Hexadecimal number F is called to octal number

View solution

Q. A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are

View solution

Q. TTL logic is preferred to DRL logic because

View solution

Q. Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits

Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.

View solution

Q. A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is

View solution

Q. What do the contents of instruction register specify?

View solution

Q. In the decimal number 27, the digital 2 represents

View solution

Q. Which of the following is true?

View solution

Q. E7F6₁₆ = __________ .

View solution

Q. What is the normal range of analog input voltage?

View solution

Q. Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

View solution

Q. For the design of a sequential circuit having 9 states, minimum number of memory elements required is

View solution

Q. ICs are

View solution

Q. A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is

View solution

Q. A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.

View solution

Q. The number of accumulators in 6800 are

View solution