Question
a.
radiation
b.
conductor heating
c.
dielectric heating
d.
all of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. When energy is fed into open wire transmission line the energy may get dissipated due to
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Loudness control gives
View solution
Q. A mobile telephone has a range of about
View solution
Q. If transmitted power is 75 kW, the field strength at 30 km distance will be about
View solution
Q. The time required for horizontal blanking is 16% of that for each horizontal line. If horizontal time is 63.5 μs, the horizontal blanking time for each line is about
View solution
Q. When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
View solution
Q. A message signal with bandwidth 10 kHz is lower sideband SSB modulated with carrier frequency fc1 = 10⁶ Hz. The resulting signal is then passed though a narrow band frequency modulator with carrier frequency fc2 = 10⁹ Hz. The bandwidth of the output would be
View solution
Q. In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor.
View solution
Q. For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
View solution
Q. The video heads, in VCR, feed the other circuit
View solution
Q. A high pulse repetition frequency in a radar
View solution
Q. In PCM, the biggest disadvantage as compared to AM is
View solution
Q. Which of the following microphones is the cheapest?
View solution
Q. If a line is terminated in characteristic impedance Z₀, the input impedance measured at the input will be
View solution
Q. In a TV, the output from RF tuner is about
View solution
Q. 24 telephone channels, each band limited to 3.4 kHz, are to be time division multiplexed by using PCM, calculate the bandwidth of PCM system for 128 quantization levels and an 8 KHz sampling frequency
View solution
Q. A signal is sampled at 8 kHz and is quantized using 8 bit uniform quantizer. Assuming SNRq for a sinusoidal signal, the correct statement for PCM signal with a bit rate of R is
View solution
Q. Generally a VCR has
View solution
Q. An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
View solution
Q. An MTI radar operating at 5 GHz has a PRF of 800 pps. The lowest blind speed is
View solution
Q. For maximum output the width of air gap of audio head should be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!