Q. The power to the base unit of a cordless telephone is supplied by

View solution

Q. In cellular telephone each cell is designed to handle

View solution

Q. A UPS contains

View solution

Q. A transmitter power of 10 W is increased by 30 dB. The effective radiated power is

View solution

Q. It is desired to couple a coaxial line to a two parallel wire line. It is best to use

View solution

Q. 24 telephone channels are frequency division multiplexed using an SSB modulation. Assuming 3 kHz per channel, the required band width is

View solution

Q. If velocity of sound waves in air at 0°C is 330 m/s, the velocity at 40°C is about

View solution

Q. A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is

View solution

Q. In FM, as bandwidth increases

View solution

Q. A 400 W carrier is amplitude modulated with m = 0.75. If single side band suppressed carrier is used the total power in modulated wave is

View solution

Q. In TV transmitter, the function of duplexer is

View solution

Q. The PSD and the power of a signal g(t) are respectively Sg(ω) and Pg, the PSD and the power of signal a.g(t) are respectively

View solution

Q. The simplest method of suppression of unwanted side band in AM is

View solution

Q. For attenuation of low frequencies we should use

View solution

Q. Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.

Reason (R): Devices using SAW principle are used in many systems.

View solution

Q. In an FM signal, the modulating frequency is 2 kHz and maximum deviation is 10 kHz. The bandwidth requirement is

View solution

Q. The effective length of antenna is different from actual length due to

View solution

Q. In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is

View solution

Q. Noise can be measured by

View solution

Q. A 100 + j 100 Ω load is to be matched to a line with Z0 = 300 Ω to give SWR = 1. The reactance of stub is

View solution