Question

In TV transmitter, the function of duplexer is

a.

to amplify video signal

b.

to remove distortions in audio signal

c.

to combine outputs of visual and audio transmitters

d.

to amplify audio signal

Answer: (c).to combine outputs of visual and audio transmitters

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In TV transmitter, the function of duplexer is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The PSD and the power of a signal g(t) are respectively Sg(ω) and Pg, the PSD and the power of signal a.g(t) are respectively

Q. The simplest method of suppression of unwanted side band in AM is

Q. For attenuation of low frequencies we should use

Q. Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.

Reason (R): Devices using SAW principle are used in many systems.

Q. In an FM signal, the modulating frequency is 2 kHz and maximum deviation is 10 kHz. The bandwidth requirement is

Q. The effective length of antenna is different from actual length due to

Q. In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is

Q. Noise can be measured by

Q. A 100 + j 100 Ω load is to be matched to a line with Z0 = 300 Ω to give SWR = 1. The reactance of stub is

Q. In VHS format each video head is tilted from azimuth by

Q. The number of possible colours with a 4 line digital input monitor are

Q. Convolution of x(t + 5) with impulse function δ(t - 7) is equal to

Q. Which of the following is a better recording medium?

Q. An angle modulated signal is given by s(t) = cos 2π (2 x 10⁶t + 30 sin 150t + 40 cos 150t). The maximum frequency and phase deviations of s(t) are

Q. Microwave link repeaters are typically 50 km apart in TV transmission due to

Q. Assertion (A): The colour signal consists of only luminance signal

Reason (R): In India PAL colour signal system is used.

Q. To separate channels in FDM receiver we have to use

Q. A device with input x(t) and y(t) is characterized by y(t) = x²(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is

Q. Assertion (A): Bandwidth of a TV signal is 5 MHz.

Reason (R): TV systems use vestigial side band transmission.

Q. In a satellite system circular polarization is to be obtained. The antenna used is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!