Question
Reason (R): FM is a constant amplitude modulation system.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R are correct but R is not correct explanation of A
c.
A is correct but R is wrong
d.
A is wrong but R is correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): In FM all power amplifiers can be operated in class C Reason (R): FM is a constant amplitude modulation system.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In radar system which of the following is called A scope
View solution
Q. In a CD the channel separation is
View solution
Q. The unit for luminous energy is
View solution
Q. The IF bandwidth of a radar receiver is inversely proportional to
View solution
Q. If the radiated power of AM transmitter is 10 kW, the power in the carrier for modulation index of 0.6 is nearly.
View solution
Q. Satellite communication uses frequencies in the range of
View solution
Q. In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
View solution
Q. Super high frequency means more than 3000 MHz.
View solution
Q. Impedance inversion may be obtained with
View solution
Q. Which of the following is correct (FDM means Frequency Division Multiplexing and TDM means Time Division Multiplexing)?
View solution
Q. Consider the following applications/ advantages of radar beacons
1. navigation
2. target identification
3. accurate tracking of enemy targets
4. large increase in maximum range
Which of the above are correct?
View solution
Q. The signal plate of vidicon tube is coated with tin oxide.
View solution
Q. The maximum permissible distance between two samples of a 10 kHz signal
View solution
Q. In telephone systems, load is expressed in the unit of
View solution
Q. Which of the following can be used to convert PPM into PWM?
View solution
Q. For an antenna of height ht metres, the radio horizon is equal to
View solution
Q. If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
View solution
Q. In the stabilized reactance modulator AFC system
View solution
Q. In AM, the modulation envelope has a peak value double the unmodulated carrier level, when the modulation is
View solution
Q. A bit synchronizer regenerates at the receiver a clock waveform which is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
