Question
a.
1°
b.
30°
c.
70°
d.
90°
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Loss angle of a good quality cable is about
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a three cavity klystron amplifier, the oscillations are excited in
View solution
Q. Assertion (A): A coaxial line is a non-radiating line.
Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.
View solution
Q. Reflex klystron oscillator is essentially a low power device
View solution
Q. A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
View solution
Q. A matched generator (Zg = Z0) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
View solution
Q. Which TM mode in rectangular waveguide has lowest cutoff frequency?
View solution
Q. The velocity factor of a transmission line depends on
View solution
Q. A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
View solution
Q. In a klystron amplifier the input cavity is called
View solution
Q. In a circular waveguide the dominant mode is
View solution
Q. The reflection coefficient on a line is 0.2 ∠45°. The SWR is
View solution
Q. For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
View solution
Q. In a travelling wave tube distributed interaction between an electron beam and a travelling wave takes place
View solution
Q. The fabrication of microstrip line is done by
View solution
Q. The condition of minimum distortion in a transmission line is
View solution
Q. A resistive microwave load with ZL = 150 Ω is connected to 50 Ω coaxial line. SWR is
View solution
Q. Which of the following devices uses a slow wave structure?
View solution
Q. In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
View solution
Q. A waveguide section in a microwave circuit acts as
View solution
Q. In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is ρ₀ the dc beam current is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
