Q. For annular flow of a fluid, the ratio of the equivalent diameter for pressure drop calculation to the equivalent diameter for heat transfer calculation is

View solution

Q. Pressure drop due to pipe fittings can be estimated by the following equation, where, Lₑ = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of Lₑ/D (dimensionless) for 45° elbow and 180° close return bends would be respectively around

View solution

Q. In a rotary drier, the average retention time of solid is (where Z = length of the drier, metres ρ = apparent solid density, kg/m³ L = flow rate of dry solids, kg/see. m² drier cross-section H = hold up of solid.)

View solution

Q. In a double pipe concentric heat exchanger, the equivalent diameter of annulus for heat transfer would be (where, D₁ and D₂ are I.D. of inner and outer pipes)

View solution

Q. For turbulent flow (Nʀe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft³/sec.ρ = fluid density, lb/ft³ μ = fluid viscosity, centipoise Dᵢ = optimum inside pipe diameter, inches)

View solution

Q. The following ratio, is normally taken as

View solution

Q. Stress-strain diagram for low carbon steel/mild steel is shown below in the Figure. The point 'A' on the Figure represents the

View solution

Q. Equivalent diameter for heat transfer calculation for a duct of square cross-section having each side as 'd' will be

View solution

Q. Friction factor for turbulent flow in a new pipe is given by

View solution

Q. In a shell and tube heat exchanger having triangular pitch, the shell side equivalent diameter is given by

View solution

Q. Pick out the wrong statement.

View solution

Q. In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)

View solution

Q. Souders Brown equation given by the following equation, is used for the calculation of the __________ in a continuous distillation column.

View solution

Q. Lₑ/D for fully open globe value may be around

View solution

Q. Lug support is

View solution

Q. Pick out the wrong statement pertaining to the use of valve tray, seive tray and bubble cap trays in continuous distillation column.

View solution

Q. With increase in the number of shell passes, the value of Fᴛ

View solution

Q. Holes of a sieve tray are arranged in triangular pitch of __________ times the hole diameter.

View solution

Q. __________ tray arrangement is recommended for distillation column having diameter upto 4 ft.

View solution

Q. What is the value of 'q' for saturated liquid feed to a distillation column ?

View solution