Question
a.
Bubble cap trays though most expensive are the best in situations, where low vapour rates is to be handled and a positive liquid seal is essential at all flow rates.
b.
Murphree efficiency of all the three trays are nearly equal, however the peak efficiency is generally higher for seive and valve trays than the bubble cap.
c.
Maintenance cost for valve and seive trays are comparatively more than bubble cap tray due to their relatively complicated construction features.
d.
Valve trays have the highest turn down ratio (i.e. the ratio of the highest to the lowest vapour flow rates) and thus provides the maximum flexible operating range.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pick out the wrong statement pertaining to the use of valve tray, seive tray and bubble cap trays in continuous distillation column.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. With increase in the number of shell passes, the value of Fᴛ
View solution
Q. Holes of a sieve tray are arranged in triangular pitch of __________ times the hole diameter.
View solution
Q. __________ tray arrangement is recommended for distillation column having diameter upto 4 ft.
View solution
Q. What is the value of 'q' for saturated liquid feed to a distillation column ?
View solution
Q. In perforated plate towers, the
View solution
Q. The main purpose of providing stepping on the trays is to
View solution
Q. The operating pressure drop range in a bag filter is about __________ mm water gauge.
View solution
Q. In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.
View solution
Q. The stress developed in a material without any permanent set is called the
View solution
Q. In a shell and tube heat exchanger, the 'tube pitch' is defined as the
View solution
Q. Which of the following is not a valid assumption in continuous binary distillation for calculating the number of equilibrium stages by Mc-Cabe-Thiele's method ?
View solution
Q. Pick out the wrong statement pertaining to the design of the bubble cap tray of a distillation column to give stable operation and even vapour distribution.
View solution
Q. Speed of the drum of the rotary vacuum filter normally ranges from __________ rpm.
View solution
Q. A stuffing box is used for
View solution
Q. Pressure drop (Δp) and the superficial gas mass velocity (G) in case of packed absorption tower operating in the preloading range are related as
View solution
Q. Pick out the wrong statement.
In an agitated vertical cylinderical reaction vessel, the
View solution
Q. The value of fouling factor depends upon the
View solution
Q. In case of bubble cap distillation column of diameter greater than 1.2 metres, the cap diameter is roughly about __________ cms.
View solution
Q. Tube side pressure drop in a 1-2 heat exchanger (for turbulent flow of fluids through the tubes) is about __________ times, that in a 1-1 heat exchanger having the same size & number of tubes and operated at the same liquid flow rate.
View solution
Q. To keep the power input constant for a stirred vessel operating under fully developed turbulent flow conditions (constant power number), if the impeller diameter is increased by 20%, the impeller speed should be decreased by a factor of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
