Question
a.
fully opens the final control element, when the measured variable is below the set point.
b.
fully closes the final control element, when the measured variable is above the set point.
c.
is a two position control (fully open or fully closed) control adequate to control a process with slow reaction and minimum dead time or transfer lag.
d.
none of these.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. On-off control
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The tensile load-elongation curve of a metal does not describe
View solution
Q. Usual value of the resistance suitable for a wire resistance strain gauge is __________ ohms.
View solution
Q. Permanent set in a material is produced by subjecting it to
View solution
Q. The following is a typical anionic collector used in flotation.
View solution
Q. Which of the following test is used for distinguishing among dry oils, semi-drying oils and non drying oils ?
View solution
Q. The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.
View solution
Q. The process of removal of scale formed during hot rolling of steel is termed as
View solution
Q. A psychrometer does not measure the __________ temperature of moist air.
View solution
Q. An ideal material for making cooking vessels should have
View solution
Q. The units of the rate constant for a second order reaction are
View solution
Q. The most serious manufacturing defect from fracture toughness point of view is
View solution
Q. Leakage in a cooking gas cylinder is detected by
View solution
Q. Which of the following is the most wear resistant grade of carbide used for the cutting tools?
View solution
Q. The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron?
View solution
Q. The malleability of a material is the property by virtue of which it can be rolled or hammered into thin sheets. Which of the following materials has the maximum malleability ?
View solution
Q. Particle nature of cathode rays is proved due to the fact that they
View solution
Q. The most commonly used moderator in nuclear power plants is
View solution
Q. Babbit lining is used on brass/bronze bearings to increase the
View solution
Q. The heat of neutralisation remains constant, when there is a reaction between dilute solutions of strong
View solution
Q. Joining of thin foils is preferred to be done by
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
