Q. Pick out the wrong statement about coating/electroplating of metals.

View solution

Q. In case of a, centrifugal pump, the ratio h1/H2 is termed as the __________ efficiency (where, h1 = actual measured head & H2 = head imparted to the fluid by impeller).

View solution

Q. Brinell hardness number (BHN) of a material is a number, which has

View solution

Q. Vanadium addition to steel improves its

View solution

Q. Tin is not present as an alloying element in

View solution

Q. Thermit welding uses the following energy source.

View solution

Q. The friction factor for the turbulent fluid flow in a rough pipe does not depend upon the

View solution

Q. Flue gases pass through the following boiler accessories in a high pressure natural circulation boiler.

A. Induced draft fan
B. Economiser
C. Air preheater
D. Steam superheater

Which of the following gives the correct sequence of flow of the flue gases through the above mentioned boiler accessories ?

View solution

Q. Case hardening of a material is

View solution

Q. Titanium is added to molten aluminium alloys before casting for the purpose of

View solution

Q. Cemented carbide tools are not suitable for cutting

View solution

Q. The difference between gross & net calorific values of fuel is due to the

View solution

Q. Which of the following is preferred for rivetting ?

View solution

Q. Heating the hypoeutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called

View solution

Q. The difference in one unit of Rockwell hardness number corresponds to a difference in the depth of indentation of __________ mm.

View solution

Q. Steel balls are manufactured by

View solution

Q. __________ temperature remains constant during adiabatic saturation process of unsaturated air.

View solution

Q. The best lubricants for a machine working at high temperature & load is

View solution

Q. One face of a furnace wall is at 1030°C and the other face is exposed to room temperature (30°C). If the thermal conductivity of furnace wall is 3 W . m⁻¹ . k⁻¹ and the wall thickness is 0.3 m, the maximum heat loss (in W/m) is

View solution

Q. Which of the following is not a principal alloying element for the structural steel?

View solution