Question
a.
condensation of the saturated vapor on a cold surface.
b.
concentration of a corrosive solution by evaporation.
c.
heat transfer between two highly viscous liquids.
d.
boiling of a liquid on a hot surface.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Leidenfrost point is a term concerned with the
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A process stream of dilute aqueous solution flowing at the rate of10 Kg.s⁻¹ is to be heated. Steam condensate at 95°C is available for heating purpose, also at a rate of 10 Kg.s⁻¹. A 1 - 1 shell and tube heat exchanger is available. The best arrangement is
View solution
Q. Heat produced when a steady state current, I passes through an electrical conductor having resistance, 'R' is
View solution
Q. Kirchoff s law applies to __________ radiation.
View solution
Q. With the increase of temperature, the Col-burn jH factor
View solution
Q. In case of evaporators, liquid entrainment results primarily due to
View solution
Q. Baffles in the shell side of a shell and tube heat exchanger
View solution
Q. Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
View solution
Q. The unit of heat transfer co-efficient in SI unit is
View solution
Q. The number of kg vaporised per kg of steam fed to the evaporator is defined as
View solution
Q. Pick out the wrong statement.
View solution
Q. Economy of a multiple effect evaporator is not influenced much by the
View solution
Q. Increasing the liquor level in the evaporator results in the
View solution
Q. Pick out the wrong statement.
View solution
Q. Convective heat transfer co-efficient in case of fluid flowing in tubes is not affected by the tube length/diameter ratio, if the flow is in the __________ zone.
View solution
Q. The actual temperature drop across the heating surface in an evaporator depends on the
View solution
Q. Which of the following is not used as a medium for high temperature heating ?
View solution
Q. Presence of a non-condensing gas in a condensing vapour
View solution
Q. The average heat transfer co-efficient for laminar film condensation on vertical surface is inversely proportional to (where, ΔT = Temperature drop across condensate film )
View solution
Q. Bulk of the convective heat transfer resistance from a hot tube surface to the fluid flowing in it, is
View solution
Q. Which of the following is concerned with both heat and mass transfer ?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!