Question
a.
2.36
b.
4.36
c.
120.36
d.
dependent on NRe only
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe, where the wall heat flux is constant, is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Among liquids, water has a comparatively high value of thermal conductivity, due to its
View solution
Q. Reynold's analogy states that (where, St = Stanton number f = friction factor)
View solution
Q. For evaporation of viscous solution in a multiple effect evaporator, the prefered feeding scheme is
View solution
Q. The sum of reflectivity and absorptivity for an opaque body is equal to
View solution
Q. The film thickness for laminar film condensation on vertical surface __________ from top to bottom.
View solution
Q. What is the steam economy in case of a single effect evaporator system ?
View solution
Q. If average heat transfer co-efficient is ha and the local coefficient at the end of the plate is hl then in case of heat transfer to a fluid flowing over a flat plate, heated over its entire length
View solution
Q. jH factor for heat transfer is not a function of the __________ number.
View solution
Q. The Fourier number (defined as a.t/L²) is used in the analysis of problem involving heat transfer by
View solution
Q. The energy radiated from a surface Q at absolute temperature T is related as
View solution
Q. A 2-4 heat exchanger involves
View solution
Q. In a liquid-liquid heat exchanger, for the same process temperature, the ratio of the LMTD in parallel flow to the LMTD in counter flow is always
View solution
Q. With increase in temperature, the thermal conductivity of steel
View solution
Q. Which of the following forced convection heat transfer equation accounts for the liquid viscosity effect for viscous liquids ?
View solution
Q. The main function of baffles provided in a shell and tube heat exchanger is to
View solution
Q. 'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a
View solution
Q. A fluid is flowing inside the inner tube of a double pipe heat exchanger with diameter 'd'. For a fixed mass flow rate, the tube side heat transfer co-efficient for turbulent flow conditions is proportional to
View solution
Q. Prandtl and Reynolds analogy are same, when Prandtl number is
View solution
Q. Heat transfer occurs by natural convection because change in temperature causes difference in
View solution
Q. The ratio of kinematic viscosity to thermal diffusivity is called the __________ number.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!