Question

During crystallisation, formation of crystal can occur in __________ solution only.

a.

saturated

b.

supersaturated

c.

undersaturated

d.

all (a), (b) and (c)

Answer: (b).supersaturated

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. During crystallisation, formation of crystal can occur in __________ solution only.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. An evaporator while concentrating an aqueous solution from 10 to 40% solids evaporates 30000 kg of water. The amount of solids handled by the system in kg is

Q. An insulator should have

Q. In a backward feed multiple effect evaporator

Q. The Grashoff number is defined as the ratio of the

Q. According to Reynolds analogy, Stanton number is equal to (where, f = Fanning friction factor)

Q. The absorptivity of a body is equal to its emissivity

Q. Absorptivity and refletivity of a perfect black body are respectively

Q. In thermal radiation for a black body (where, ε is emissivity and α is absorptivity)

Q. Viscous & heat sensitive liquids are concentrated in __________ evaporators.

Q. 1 BTU/hr.ft.°F is equal to __________ kcal/hr. m.°C.

Q. Heat transfer by radiation between two bodies at T1 & T2 and in an ambient temperature of Ta°C depends on

Q. The ratio of momentum diffusivity to thermal diffusivity is the __________ number.

Q. For a perfectly transparent surface (like gases), the

Q. Water is normally used as a coolant in the heat exchange equipments mainly because of its

Q. The rate of emission of radiation by a body does not depend upon the

Q. Which of the following has maximum thermal conductivity at the same temperature?

Q. Maximum heat transfer rate is obtained in __________ flow.

Q. In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface.

Q. The ratio of velocity head to tube side return loss in case of a multipass shell and tube heat exchanger is

Q. Terminal point temperature differences between fluids in case of a heat exchanger is termed as

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!