Q. Pick out the wrong statement.

View solution

Q. The type of liquor circulation system to be employed in evaporators (viz. natural or forced circulation) is determined mainly by the __________ of the liquid.

View solution

Q. Thermal diffusivity is the most important in heat transfer by

View solution

Q. (NGr x NPr) is called the __________ number.

View solution

Q. A dephlegmator is a

View solution

Q. Rate of crystallisation does not depend upon the

View solution

Q. Stefen's block body radiation law can also be derived from __________ law.

View solution

Q. Multipass heat exchangers are used

View solution

Q. A hollow sphere and a solid sphere of the same material and equal radii are heated to the same temperature. In this case,

View solution

Q. Condensing film co-efficient for steam on horizontal tubes ranges from 5000 to 15000 Kcal/hr.m² .°C. Condensation of vapor is carried out inside the tube in a shell and tube heat exchanger, when the

View solution

Q. Viscosity of gases __________ with increase in temperature.

View solution

Q. What is the emissivity of a black body ?

View solution

Q. Steam is routed through the tube in case of a __________ evaporator.

View solution

Q. Dropwise condensation of steam on cooling surface is promoted

View solution

Q. Conduction occurs in the buffer zone for a fluid flowing through a heated pipe, only when Prandtl number is

View solution

Q. The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as

View solution

Q. Maximum heat transfer rate is achieved in __________ flow.

View solution

Q. Wavelength corresponding to the maximum energy is inversely proportional to the absolute temperature. This is __________ law.

View solution

Q. Three material A, B and C of equal thick-nes and of thermal conductivity of 20, 40 & 60 kcal/hr. m. °C respectively are joined together. The temperature outside of A and C are 30°C and 100°C respectively. The interface between B and C will be at a temperature of __________ °C.

View solution

Q. The unit of conductance in SI unit is

View solution