Question
a.
extent of supersaturation.
b.
turbulence within the solution.
c.
number and active surface area of the crystals.
d.
none of these.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Rate of crystallisation does not depend upon the
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Stefen's block body radiation law can also be derived from __________ law.
View solution
Q. Multipass heat exchangers are used
View solution
Q. A hollow sphere and a solid sphere of the same material and equal radii are heated to the same temperature. In this case,
View solution
Q. Condensing film co-efficient for steam on horizontal tubes ranges from 5000 to 15000 Kcal/hr.m² .°C. Condensation of vapor is carried out inside the tube in a shell and tube heat exchanger, when the
View solution
Q. Viscosity of gases __________ with increase in temperature.
View solution
Q. What is the emissivity of a black body ?
View solution
Q. Steam is routed through the tube in case of a __________ evaporator.
View solution
Q. Dropwise condensation of steam on cooling surface is promoted
View solution
Q. Conduction occurs in the buffer zone for a fluid flowing through a heated pipe, only when Prandtl number is
View solution
Q. The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as
View solution
Q. Maximum heat transfer rate is achieved in __________ flow.
View solution
Q. Wavelength corresponding to the maximum energy is inversely proportional to the absolute temperature. This is __________ law.
View solution
Q. Three material A, B and C of equal thick-nes and of thermal conductivity of 20, 40 & 60 kcal/hr. m. °C respectively are joined together. The temperature outside of A and C are 30°C and 100°C respectively. The interface between B and C will be at a temperature of __________ °C.
View solution
Q. The unit of conductance in SI unit is
View solution
Q. In a shell and tube heat exchanger, square pitch compared to triangular pitch
View solution
Q. Which of the following has maximum thermal conductivity ?
View solution
Q. A wall has two layers of materials A and B; each made of a different material. Both the layers have the same thickness. The thermal conductivity of materialA is twice that of B. Under the equilibrium, the temperature difference across the wall is 36°C. The temperature difference across the layer A is __________ °C.
View solution
Q. The film co-efficient between condensing vapour and metal wall increases with
View solution
Q. A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
View solution
Q. Heat sensitive materials can be concentrated in an evaporator employing
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!