Q. The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as

View solution

Q. Maximum heat transfer rate is achieved in __________ flow.

View solution

Q. Wavelength corresponding to the maximum energy is inversely proportional to the absolute temperature. This is __________ law.

View solution

Q. Three material A, B and C of equal thick-nes and of thermal conductivity of 20, 40 & 60 kcal/hr. m. °C respectively are joined together. The temperature outside of A and C are 30°C and 100°C respectively. The interface between B and C will be at a temperature of __________ °C.

View solution

Q. The unit of conductance in SI unit is

View solution

Q. In a shell and tube heat exchanger, square pitch compared to triangular pitch

View solution

Q. Which of the following has maximum thermal conductivity ?

View solution

Q. A wall has two layers of materials A and B; each made of a different material. Both the layers have the same thickness. The thermal conductivity of materialA is twice that of B. Under the equilibrium, the temperature difference across the wall is 36°C. The temperature difference across the layer A is __________ °C.

View solution

Q. The film co-efficient between condensing vapour and metal wall increases with

View solution

Q. A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of

View solution

Q. Heat sensitive materials can be concentrated in an evaporator employing

View solution

Q. A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires

View solution

Q. In a shell and tube heat exchanger, floating head is used for

View solution

Q. Steam trap is used to

View solution

Q. Kirchoff's law is applicable to

View solution

Q. In a forward feed multiple effect evaporator, the pressure is

View solution

Q. In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation will

View solution

Q. Which of the following situations can be approximated to a steady state heat transfer system ?

View solution

Q. Sensible heat absorbed by 1 lb of water when it is heated from 32 to 212°F may be around __________ BTU.

View solution

Q. In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid

View solution