Question
a.
gives a higher shell side pressure drop.
b.
gives a lower shell side pressure drop.
c.
can pack more surface area into a shell of given diameter.
d.
none of these.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a shell and tube heat exchanger, square pitch compared to triangular pitch
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which of the following has maximum thermal conductivity ?
View solution
Q. A wall has two layers of materials A and B; each made of a different material. Both the layers have the same thickness. The thermal conductivity of materialA is twice that of B. Under the equilibrium, the temperature difference across the wall is 36°C. The temperature difference across the layer A is __________ °C.
View solution
Q. The film co-efficient between condensing vapour and metal wall increases with
View solution
Q. A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of
View solution
Q. Heat sensitive materials can be concentrated in an evaporator employing
View solution
Q. A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires
View solution
Q. In a shell and tube heat exchanger, floating head is used for
View solution
Q. Steam trap is used to
View solution
Q. Kirchoff's law is applicable to
View solution
Q. In a forward feed multiple effect evaporator, the pressure is
View solution
Q. In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation will
View solution
Q. Which of the following situations can be approximated to a steady state heat transfer system ?
View solution
Q. Sensible heat absorbed by 1 lb of water when it is heated from 32 to 212°F may be around __________ BTU.
View solution
Q. In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid
View solution
Q. With increase in temperature, the total emissivity of conductors
View solution
Q. Loss of heat from untagged steam pipe to the ambient air is by
View solution
Q. Fruit juice (a heat sensitive material) can be concentrated in a __________ evaporator.
View solution
Q. Tubes are held between top and bottom tube sheets in Calenderia type evaporator by keeping
View solution
Q. Nusselt number is the ratio of the temperature gradient at the wall to
View solution
Q. The Stefan-Boltzman constant depends on the
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!