Question
a.
An increased weir height improves the tray efficiency at the cost of high plate pressure drop; optimum wear height being 40-90 mm for column pressure above atmospheric and 6-12 mm for vacuum columns.
b.
For segmental downcomers, the chord length is 60-80% of the column diameter. An initial value of downcomer area of 12% is taken in the design.
c.
Width of the calming section provided at the inlet and outlet sides of the plate is 75 mm for column diameter below 1.5 metres and 100 mm for larger diameter columns.
d.
Minimum recommended downcomer residence time for the disengagement of entrained vapour is the same for both foaming and non-foaming liquids, which is about 20 seconds.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pick out the wrong statement about the design of a sieve plate column.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Generally, no corrosion allowance in wall thickness of a part is required, if the thickness is more than __________ mm.
View solution
Q. Multiple blade paddle agitator is used for mixing high viscosity liquids/paste in which the paddle diameter is commonly 0.8 times the tank diameter. However, the width of the blade is in the range of __________ times the paddle diameter.
View solution
Q. In a __________ rivetted joint, the rivets in the various rows are opposite to each other.
View solution
Q. Pick out the wrong statement:
View solution
Q. Speed of industrial paddle agitator ranges from __________ rpm.
View solution
Q. __________ strain is measured using a 'strain rosetter'.
View solution
Q. Thin spherical shells subjected to internal pressure, develop __________ stresses.
View solution
Q. With increase in the reflux ratio for a fixed production from a continuous binary distillation column, the __________ decreases.
View solution
Q. The slope of operating line in the rectifying section of a distillation column is unity, if the reflux ratio is
View solution
Q. Thickness of the frame of a plate and frame filter as compared to that of plates is
View solution
Q. Which of the following factors affect the pressure drop in a co-current gas-liquid absorption packed tower ?
View solution
Q. The thickness of heat transfer plates used in the plate type heat exchanger ranges from __________ mm, pressed in a single piece provided with grooves & corrugations.
View solution
Q. Rivets are generally specified by the
View solution
Q. Length to diameter ratio of most rotary driers is in the range of
View solution
Q. Vertical vessels are not supported by
View solution
Q. With increase in pressure drop (for a given particle size), the dust collection efficiency of a cyclone separator will
View solution
Q. Spherical shaped pressure vessel is considered to be the most ideal, because it can
View solution
Q. An adequate clearance between the tray and the shell wall of a distillation column is provided to
View solution
Q. Overall tray efficiency of a distillation column is the ratio of the number of
View solution
Q. Number of evaporators which can be used in service in a multiple effect evaporation system is limited by the
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
