Q. The thickness of heat transfer plates used in the plate type heat exchanger ranges from __________ mm, pressed in a single piece provided with grooves & corrugations.

View solution

Q. Rivets are generally specified by the

View solution

Q. Length to diameter ratio of most rotary driers is in the range of

View solution

Q. Vertical vessels are not supported by

View solution

Q. With increase in pressure drop (for a given particle size), the dust collection efficiency of a cyclone separator will

View solution

Q. Spherical shaped pressure vessel is considered to be the most ideal, because it can

View solution

Q. An adequate clearance between the tray and the shell wall of a distillation column is provided to

View solution

Q. Overall tray efficiency of a distillation column is the ratio of the number of

View solution

Q. Number of evaporators which can be used in service in a multiple effect evaporation system is limited by the

View solution

Q. Which of the following is used to set the diameter of the distillation column ?

View solution

Q. Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele's method, this method

View solution

Q. The optimum size ratio for two mixed reactors in series depends on the kinetics of the reaction and the conversion level. For reaction orders more than one, the

View solution

Q. In a shell and tube heat exchanger, tube side __________ of the mass velocity.

View solution

Q. Cooling water fouling factors vary in the range of 0.001 to 0.003

View solution

Q. Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter )

View solution

Q. The maximum liquid gradient over a tray must not exceed

View solution

Q. An underdesigned steam trap will

View solution

Q. The slope of the feed line in distillation opeartion is given by (where, q = fraction of the feed stream that is liquid.)

View solution

Q. Needle valves are generally not used for

View solution

Q. Height equivalent to a theoretical plate (HETP) is the height of packing that will give the same separation as one theoretical plate in gas-liquid mass transfer operations like distillation, absorption/stripping and humidification/dehumidification. HETP which is experimentally determined, depends upon the

View solution