Question
a.
reducing scale deposition.
b.
increasing pressure drop.
c.
fixing the tubes.
d.
creating turbulence.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For turbine agitator, the impeller diameter is about
View solution
Q. If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will __________ times.
View solution
Q. __________ of water makes it a widely used coolant in heat exchangers.
View solution
Q. The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area 'A' is given by (where, P = perimeter of the channel in contact with the fluid)
View solution
Q. Fouling factor must be included in the calculation of over all design heat transfer coefficient, when the liquid
View solution
Q. Lug support is meant for supporting __________ vessels.
View solution
Q. Overall mass transfer co-efficient in case of absorption of __________ in water is based on the gas film co-efficient only, as the mass transfer process is gas film (phase) controlling.
View solution
Q. Most of the storage vessels/tanks are made cylindrical, because of the fact that a cylinder
View solution
Q. The distance between the top of the slots and the liquid surface when the static liquid is just ready to flow over the overflow weir is called
View solution
Q. Liquid gradient over the tray results due to the
View solution
Q. The centre to centre distance between two consecutive baffles in a shell and tube heat exchanger is called the baffle pitch or baffle spacing, which is more than 1/5th the I.D. of the shell. Which of the following is not a function of the baffles ?
View solution
Q. Bubble cap plate column is
View solution
Q. In seive plate column, holes are drilled or punched in sizes ranging from 2.5 to 12 mm (5 mm being widely used). The hole pitch is normally __________ times the hole diameter to give the required hole area.
View solution
Q. Pick out the wrong statement.
View solution
Q. The force due to wind load acting on a tall vessel depends upon its
View solution
Q. Bubble cap diameter used for the distillation column having diameter ranging from 1.5 to 4.5 metres is about __________ mm.
View solution
Q. Power required for agitation depends upon the
View solution
Q. Tube height in a calendria type evaporator is normally less than __________ metres.
View solution
Q. Pick out the wrong statement.
View solution
Q. For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!