Q. The distance between the top of the slots and the liquid surface when the static liquid is just ready to flow over the overflow weir is called

View solution

Q. Liquid gradient over the tray results due to the

View solution

Q. The centre to centre distance between two consecutive baffles in a shell and tube heat exchanger is called the baffle pitch or baffle spacing, which is more than 1/5th the I.D. of the shell. Which of the following is not a function of the baffles ?

View solution

Q. Bubble cap plate column is

View solution

Q. In seive plate column, holes are drilled or punched in sizes ranging from 2.5 to 12 mm (5 mm being widely used). The hole pitch is normally __________ times the hole diameter to give the required hole area.

View solution

Q. Pick out the wrong statement.

View solution

Q. The force due to wind load acting on a tall vessel depends upon its

View solution

Q. Bubble cap diameter used for the distillation column having diameter ranging from 1.5 to 4.5 metres is about __________ mm.

View solution

Q. Power required for agitation depends upon the

View solution

Q. Tube height in a calendria type evaporator is normally less than __________ metres.

View solution

Q. Pick out the wrong statement.

View solution

Q. For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.

View solution

Q. Cylinderical shell thickness of rotary drier is generally __________ mm.

View solution

Q. The ratio of lateral strain to linear strain is termed as the

View solution

Q. The distance between the centre of a rivet hole to the nearest edge of the plate is called

View solution

Q. Mc Cable Thiele method used for finding theoretical stages in a distillation column assumes that the

View solution

Q. A minimum clearance of about __________ mm is maintained between the distillation column wall and the bubble cap.

View solution

Q. Lₑ/D for 90° elbow (medium radius) and 90°square elbow would be respectively around

View solution

Q. __________ heat exchanger is also known as 'hair pin type' exchanger,

View solution

Q. What is the value of 'q' for saturated vapor feed to a distillation column ?(where q = fraction of the feed stream that is liquid.)

View solution