Q. Steady flow occurs, when the

View solution

Q. With increase in the ratio of orifice diameter to pipe diameter, the fraction of the orifice pressure differential that is permanently lost

View solution

Q. Pick out the wrong statement:

View solution

Q. Medium viscosity lubricating oil can be most ideally pumped by a __________ pump.

View solution

Q. In a fully turbulent flow (Re > 10⁵) in a pipe of diameter 'd', for a constant pressure gradient, the dependence of volumetric flow rate of an incompressible fluid is

View solution

Q. Pump used for the transportation of molten sodium in a fast breader reactor is a/an __________ pump.

View solution

Q. Small pressure differences in liquids is measured using a/an

View solution

Q. Venturimeters, orificemeters and nozzles are used to measure the fluid discharge from a pipeline. The average fluid velocity in a pipeline can be measured by a/an

View solution

Q. The time taken for gravity flow of a fixed volume of liquid (as in Redwood viscometer) is directly proportional to its

View solution

Q. The exit cone angle in case of a standard venturimeter is __________ the entrance cone angle.

View solution

Q. Sewage sludge is __________ type of non-Newtonion fluid.

View solution

Q. Ratio of pressure and inertia force gives __________ number.

View solution

Q. The terminal velocity of a solid spherical particle falling through a stationary fluid mass in the Stoke's law range is proportional to the

View solution

Q. Which of the following equations as suggested by Colebrook and White gives the increase in roughness of a new surface (ε₀) with age/time (t) (where, ε = roughness of the surface after time't'. α = a co-efficient to be experimentally determined)?

View solution

Q. Fluidised beds are formed, when the

View solution

Q. A fluid is pumped at the rate of 10 lb/sec to a height of 55 ft. The horse power required is __________ hp.

View solution

Q. With increase in pump speed, its NPSH requirement

View solution

Q. In the Newton's law range, the terminal velocity of a solid spherical particle falling through a stationary fluid mass is __________ the fluid viscosity.

View solution

Q. Gear pump

View solution

Q. Most of the centrifugal pumps used in chemical plants are usually __________ driven.

View solution