Q. Length/diameter ratio of a ball mill is

View solution

Q. Feed size of ≥ 25 cms can be accepted by

View solution

Q. Which is the most suitable conveyor for transportation of sticky material ?

View solution

Q. The most suitable equipment for removing the fine dust particle (< 1 micron dia.) from air below its dew point will be a/an

View solution

Q. Laminar flow region is said to exist during agitation of a liquid in an agitator, when the value of Reynolds number is

View solution

Q. Basic slag is not ground in

View solution

Q. Grindability of a material does not depend upon its

View solution

Q. Shape factor for a cylinder whose length equals its diameter is

View solution

Q. In case of a hammer crusher, the

View solution

Q. Dust laden air can be purified using a

View solution

Q. Energy consumed for crushing one ton of material ranges from __________ kWh.

View solution

Q. For transporting pasty material, one will use a/an

View solution

Q. Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a

View solution

Q. A tube mill compared to a ball mill

View solution

Q. Trommels separate a mixture of particles depending on their

View solution

Q. Size reduction does not occur due to compression in case of

View solution

Q. According to Taggart's rule for selecting between a gyratory crusher and a jaw crusher; the later should be used, if the hourly tonnage to be crushed divided by the square of the gape expressed in cm is less than

View solution

Q. Which of the following represents the plot of filtrate volume versus time for constant pressure filtration ?

View solution

Q. Driving force in case of filtration by a centrifuge is the

View solution

Q. Rod mills employed for grinding

View solution